Enviro M55C-FPI El manual del propietario

The burner system of this pellet stove is designed to actively manage the waste by-products of combustion. As a result, you can enjoy the longest cle

Routine Cleaning and MaintenanceThe following list of components should be inspected and maintained routinely to ensure that the applian

Figure 9: M55C-FPI Heat Exchanger Cleaning.11Routine Cleaning and MaintenanceHeat eXcHangeR tubeS (Weekly)The exchanger tube scraper rod handle is loc

Routine Cleaning and MaintenanceEXHAUST PASSAGES (Biannually)12Figure 10: M55C-FPI Exhaust Passages.1. Swing open the cast door, and unlatch the fi

Routine Cleaning and MaintenanceOptional Service Rail Kit (Part number 50-2262)13Figure 11: M55C-FPI with Service Rail KitFigure 12: Close up of Fro

Technical installation instructionsFoR QuaLiFied inStaLLeRS onLy14

Installationdeciding WHeRe to Locate youR peLLet appLiance:1. Unit must be installed in a masonry fireplace.2. Do not install the stove in a bedroom o

InstallationFigure 4: M55C-FPI Frame. inStaLLing tHe inSeRt FRame & LeveLLing:Warning: Careless installation is the major cause of safety hazards.

InstallationcLeaRanceS to combuStibLeS:Figure 4: M55C-FPI Clearance to Combustibles. tHeRmoStat inStaLLation:1. Install the wall thermostat (millivolt

2. Vent surfaces can become hot enough to cause burns if touched by children. Non-combustible shielding or guards may be required.3. T

InstallationoutSide FReSH-aiR connection:This Heater must have adequate air for proper combustion in the room that it is installed.Figure 7: Outside A

Table of Contents2Introduction...3Rating L

InstallationInstallationmaSonRy FiRepLace inStaLLation:A non-combustible manufactured hearth pad (min. 24 gauge galvanized steel or similar) must

InstallationpoSitive FLue connection WitHout a FuLL ReLine (uSa onLy):This unit does not require a full reline (in USA only) when installing into a ma

InstallationbuiLt-in inStaLLation:Installation without a masonry replace -The M55C-FPI can be installed without an existing masonry replace by build

InstallationHoRizontaL eXHauSt tHRougH WaLL inStaLLation:Vent installation: install vent at clearances specified by the vent manufacturer.A chimney c

InstallationRecommended - tHRougH WaLL WitH veRticaL RiSe and HoRizontaL teRmination inStaLLation:Figure 12: Venting horizontally with rise. NOTE - Th

Figure 13: Outside Vertical Installation. InstallationoutSide veRticaL inStaLLationS:To accomplish an outside vertical pipe installation, follow the “

InstallationinSide veRticaL inStaLLationS:1. Install a tee or 90° elbow on the inside of the house.2. Install PL vent upward from the tee. Make sure

TroubleshootingDO NOT:● Service the stove with wet hands. The stove is an electrical appliance, which may pose a shock hazard if handled improperly.

Troubleshooting• Exhaust Temperature Sensor failure. Bypass sensor located on Exhaust Blower, if stove now operates properly, the unit may require cl

Troubleshooting7. The convection blower will not function normally. • Check the line fuse to see if it has blown.• Clean all grill openings at the b

3Introduction* This manual is designed for the home owner in conjunction with the technical manual. *Rating LabeL Location:The rating label is located

Wiring DiagramIgnitorRedWhiteRedWhiteAir PumpExhaust Temperature SensorBrownBrownHigh Limit Temperature SwitchOrangeOrangePurpleWhiteConvection Blower

Parts ListReference # Description Part #OPTION Log Set 50-1963OPTION M55CI O/S Filler Panel 50-2155OPTION Pellet Stove Thermostat 50-1971OPTION Glass

Parts ListReference # Description Part #37 M55C-FPI Control Panel with Decal 50-226738 Exhaust Channel CW Sensor 50-228639 Bafe 50-228740 ¼” Spring P

Parts ListReference # Description Part #67 M55C-FPI Cast Side Right - PD 50-227067 M55C-FPI Cast Side Right - Beach 50-227567 M55C-FPI Cast Side Right

Parts Diagram - Components6481234823141011159292174224125425171618405224541494752531319 203734

Parts Diagram - Steel697038285726276356261365159666768 64653037394435

36

37NAME OF OWNER:_________________________________________ADDRESS:_____________________________________________________________________________________

4Safety Warnings & RecommendationsPlease read this entire Owner’s Manual before installing or operating your Enviro Pellet Stove. Failure to follo

5Safety Warnings & RecommendationsELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded elect

SpecificationsdimenSionS:Figure 1: Dimensions of M55C-FPI. 6SpeciFicationS:Input rating when using: Wood Pellets/Corn - 55,000BTU (16.1KW•hr) & Wh

7Operating InstructionscontRoL boaRd FunctionS:Note: The Control Panel is located underneath the units Cast Hopper Lid which is attached to a safety

8Operating InstructionsopeRating youR peLLet Stove:THE UNIT WILL NOT OPERATE WITH THE DOOR OR ASH BOX OPEN. Open the hopper lid only to re-fuel or to

9NOTE: THE SURROUNDPANEL MOUNT WASREMOVED FOR CLARITYCONVECTIONFANSLIDERDAMPEREXHAUSTCHANNELEXHAUST SENSOR &REMOVABLE PLATEsetting. If the therm